- Available with offsets
- Factory eave notching available
- Herr-Voss corrective leveled
- Stiffener beads available
- 20 year non-prorated finish warranty
- Maximum panel length of 45 feet
- 37 stocked colors (24 ga. steel)
- Stucco embossed can be specified
- 36 stocked colors (.032 aluminum)
Redi-Roof metal roofing batten panel is an architectural roofing system available exclusively from Petersen Aluminum Corporation. It is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are to be factory roll-formed in continuous lengths. Maximum panel length is 45 feet and minimum panel length is 4 feet.
The Redi-Roof metal roofing panel features an offset profile which adds strength and allows room for a hex head fastener. The clip, with its button punched design, insures an extra-snug fit.
Trim
All flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year warranty can be supplied covering finish performance.
Installation
Redi-Roof Panels shall be installed over solid decking with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen non-penetrating clips, fastening on 18″ centers (max.). Minimum slope at 3:12 pitch. Redi-Roof Batten panels cannot be lapped in the field. Consult a local architect/engineer for requirements of local codes and conditions.
Curved Batten Panel
The Redi-Roof Batten Panel is the industry’s only batten panel which can be radiused concave or convex with a minimum radius of 9 ft. This panel is ideal for barrel vaults and cornices. Curved panels must be installed over a waterproofed solid substrate.
