REDI-ROOF^™ BATTEN

Redi-Roof Metal Roofing is an architectural metal roofing system available exclusively from Petersen Aluminum Corporation. Is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are to be factory roll-formed in continuous lengths. Maximum panel length is 45 feet and minimum panel length is 4 feet.

Redi-Roof Panels feature an offset profile which adds strength and allows room for a hex head fastener. The clip, with its button punched design, insures an extra-snug fit.

Trim

All flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year warranty can be supplied covering finish performance.

Installation

Redi-Roof Panels shall be installed over solid decking with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen non-penetrating clips, fastening on 18" centers (max.). Minimum slope at 3:12 pitch. Redi-Roof Batten panels cannot be lapped in the field. Consult a local architect/engineer for requirements of local codes and conditions.

Curved Batten Panel

The Redi-Roof Batten Panel is the industry's only batten panel which can be radiused concave or convex with a minimum radius of 9 ft. This panel is ideal for barrel vaults and cornices. Curved panels must be installed over a waterproofed solid substrate.