Metal Roofing

REDI-ROOF^® STANDING SEAM

REDI-ROOF STANDING SEAM

Hill Middle School

REDI-ROOF STANDING SEAM

Pinehurst City

Product Features
Materials

Available with or without offsets
Factory eave notching available
Herr-Voss corrective leveled
Labor-saving one-piece design

Stiffener beads available
20 year non-prorated finish warranty
Maximum panel length of 45 feet

37 stocked colors (24 ga. steel)
36 stocked colors (.032 aluminum)

Stucco embossed can be specified

Redi-Roof Metal Roofing is an architectural metal roofing system available exclusively from Petersen Aluminum Corporation. It is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are to be factory roll-formed in continuous lengths. Maximum panel length is 45 feet and minimum panel length is 4 feet.

Redi-Roof Panels feature an offset profile which adds strength and allows room for a hex head fastener. The clip, with its button punched design, insures an extra-snug fit. The one-piece design of the Redi-Roof Standing Seam allows for ease of installation.

Trim

All flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year warranty can be supplied covering finish performance.

Installation

Redi-Roof Panels shall be installed over solid decking with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen non-penetrating clips, fastening on 18" centers (max.). Minimum slope at 3:12 pitch. Redi-Roof Batten panels cannot be lapped in the field. Consult a local architect/engineer for requirements of local codes and conditions.