TITE-LOC

Tite-Loc Metal Roofing Panels combine structural panel performance with architectural panel aesthetics. TITE-LOC Panels are corrective leveled to provide superior panel flatness. A factory-applied sealant bead is applied for additional weather resistance. Maximum panel length is 64 feet and minimum panel length is 4 feet. Consult factory for longer lengths.

Tite-Loc Panels feature a 2" leg height that requires mechanical field seaming after installation. Panels have a concealed-fastener floating clip system designed to allow for thermal expansion/contraction. For further details, please contact PAC.

Trim

All flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.063 gauge as specified) or PAC-CLAD steel (24 ga. or 22 ga. as specified). A 20 year, non-prorated finish warranty can be supplied covering finish performance.

Installation

Tite-Loc Panels are intended for use in architectural and structural roofing. Substrates may include 5/8" (min.) plywood, nailboard insulation or equal with an underlayment of ice and water shield or 30# (min.) roofing felt applied horizontally from eave to ridge. Other substrates may include metal decking, purlins or rigid insulation in conjunction with bearing plates.

A minimum 1/2:12 pitch is required. Contact Petersen for further detail assistance on projects. For Coastal applications, aluminum panels along with stainless steel clips must be used for warranty. Consult a local architect/engineer for compliance with local codes and conditions.

Tite-Loc Panels

Tite-Loc Panels are factory-formed to length and field seamed to a 90° lock. Tite-Loc panels have been designed for application on roof slopes as low as 1/2:12 pitch. Tite-Loc panels are available in 12", 16" and 18" widths. Materials available include 22 and 24 gauge steel; .032 and .040 aluminum.

Tite Loc Seaming

The Tite-Loc seamer is bi-directional, offering labor savings with the ability to travel up and down slope. However, the seamer should only be used up slope on roofs with a pitch of 4:12 or less.

Curved Tite-Loc Panels

Tite-Loc Panels can be curved to a minimum radius of 20"-0". Tite-Loc curving can be done in the field or at the factory depending on the radius and length of the panel. For more details about our capabilities, please contact Petersen Aluminum Corporation.