FLUSH & REVEAL WALL

PAC-CLAD Flush Panels are designed for wall, fascia and soffit applications where a flush or flat appearance is desired. A rounded interlock leg and concealed fastening system improves the flush appearance while providing additional strength. Panels are factory-formed to length to minimize field cutting. Maximum panel length is 25 feet and minimum panel length is 4 feet.

PAC-CLAD Flush Panels are available in on-center dimensions designed to complement our roofing panel product line. Flush Panels are available in two configurations: Flush Panel and Reveal Panel.

Applications

Uses: PAC-CLAD Flush Panels are intended for use in vertical wall, fascia and soffit applications. Flush Panels are not intended for use in roofing or mansard applications.

Stiffening Beads

The Flush Panel and Reveal Panel are available with optional stiffening beads. Stiffening beads are recommended for longer panel lengths. One or two beads are available.

Installation

PAC-CLAD Flush Panels shall be installed over a solid deck/wall with appropriate 30# felt or ice and water shield, or in limited applications, over framing sections. When used in a windscreen application, panels must be fastened (stitched) through side joints. Consult a local architect/engineer for requirements of local codes and conditions.

Corrective Leveling

Petersen Flush Panels are formed on precision roll-forming equipment that includes in-line Herr-Voss corrective levelers. Corrective leveling works to remove typical metal conditions including coil set, crowning and edge wave. In-line leveling capabilities allow us to work with source material that is "still-water" flat. The result is a panel that exhibits superior flatness. Corrective leveling is available at no extra charge.