Redi-Roof is an architectural metal roofing system available exclusively from Petersen Aluminum Corporation. It may be specified in either a batten or standing seam profile and is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are to be factory roll-formed in continuous lengths (minimum panel length is 4 ft.).

Redi-Roof Panels feature an offset profile which adds strength and allows room for a hex head fastener. The clip, with it's button punched design, insures an extra-snug fit. The one-piece design of the Redi-Roof Standing Seam allows for ease of installation.

UL 90 Classified
Steel Redi-Roof Panels carry a UL-90 classification for wind uplift when fastened to an underlayment assembly including 5/8” plywood or OSB (oriented strand board) laminated to rigid insulation (UL Construction No. 350, 353 & 615). For further details contact Petersen Aluminum Corporation.

Air and Water Infiltration
Petersen Redi-Roof Panels meet the full performance requirements of the ASTM E 283 air infiltration test and the ASTM E 331 water penetration test when applied over a solid substrate. For complete test results, contact Petersen Aluminum Corporation.

Materials
a) 24 ga. G-90 hot dipped galvanized steel
b) .032 3105-H14 aluminum or equal
c) 16 oz. cold rolled copper
(standing seam only)

Trim
All flashing and trim will be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032-.080 gauge as specified) or PAC-CLAD steel (22 ga. or 24 ga. as specified). A 20 year warranty shall be supplied covering finish performance.

Installation
PAC-CLAD Redi-Roof shall be installed over solid decking with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen non-penetrating clips, fastening on 18" centers (max.). Minimum slope at 3:12 pitch. Redi-Roof Batten panels cannot be lapped in the field. Consult a local architect/engineer for requirements of local codes and conditions.

Curved Batten Panel
The Redi-Roof Batten Panel is the industry's only batten panel which can be radiused concave or convex with a minimum radius of 9 ft. This panel is ideal for barrel vaults and cornices. Curved panels must be installed over a waterproofed solid substrate.