Tapered Projects a SNAP with PAC SNAP-CLAD


Outstanding design flexibility and proven strength of the Petersen Aluminum Snap-Clad panel are just two factors contributing to the successful completion of Ware County High School Project, located in southeastern Georgia. Long-recognized as the ideal selection for standing seam metal roof applications due to its superior aesthetics and unmatched long-term performance, PAC also provides the ability to custom fabricate the panels for precise fit in conical roof sections.


PAC worked closely with roofing contractor Roofing Professionals Inc. (RPI), of Richmond Hill, GA, to ensure the custom-produced panels not only fit perfectly, but also minimized field-waste on the project. The project featured 2200 SF of tapered Snap Clad in 24 GA PAC-CLAD Kynar-coated Hartford Green for the conical areas, plus another 2000 SF of Snap-Clad panels for the straight areas.


But the challenges for the roofing installation didn’t end there. The project also consisted of several curved roof areas, which required the Petersen Tite-Loc, 90-degree mechanically seamed panel. Tite-Loc is the superior selection for curved applications that require a radius of a minimum of 20’, and in some cases, even less. (Contact your local PAC factory for specific curving capabilities in your area.) A slight curve to the main areas of the roof meant the panels would “lay down” in the field. But panels over the building’s canopy required onsite field curving, which again demanded considerable coordination between RPI, PAC distributor Commercial Roofing Specialties of Savannah, GA,  and the PAC staff at our Acworth, GA branch. The 16,500 SF of curved and straight Tite-Loc Panels were also produced in 24 GA steel in Hartford Green.


The Architect-of-Record for this Waycross, GA project was Doug Neal Architects of St. Simons Island, GA.

Tags: ,

Leave a Reply

You must be logged in to post a comment.

Snap-Clad Panel
Tite-Loc Panel
Tite-Loc Plus Panel
Tite-Loc HS Panel
Snap-On Standing Seam Panel
High Snap-On Standing Seam Panel
Snap-On Batten Panel
Redi-Roof Standing Seam Panel
Redi-Roof Batten Panel
ColorGard® Snow Retention System
PAC-150 90° Single Lock
PAC-150 180° Double Lock
M-42 & M-36 Panels
7.2 Panel
1/2″ & 7/8″ Corrugated Panel
R-41 & R-36 Panels
Coil and Flat Sheet
Flashing and Trim
Custom Fabrication
Anodized Aluminum
Copper & Stainless Steel
PAC-750 Soffit
PAC-850 Soffit
Flush/Reveal Soffit
PAC-1000F Column Cover
PAC-1000C Column Cover
PAC-1000R Column Cover
PAC-2000F Column Cover
PAC-2000C Column Cover
PAC-2000R Column Cover
PAC SS Vented Eave & Intake Vent
PAC ECO Vented Fascia
PAC SS Rake Panel & Fascia
PAC SS Ridge Vents
PAC-TITE Angular Fascia
PAC-TITE WT Canted Fascia
PAC-TITE WT Extended Fascia
PAC-LOC Fascia
PAC Snap Edge Fascia
PAC Extended Snap Edge Fascia
PAC-TITE Gold Coping
PAC-Continuous Cleat Coping
Precision Series Wall Panels
Composite Wall Panels
Flush/Reveal Wall Panels