PAC-Green
COVID-19
Updates

Due to a confirmed case of COVID-19 with one of our employees, the Annapolis Junction, Md., facility will be temporarily shut down for cleaning. In compliance with CDC guidelines, other Annapolis Junction employees are in self-quarantine. The site is scheduled to reopen on June 1. All orders that typically would be processed by the Maryland facility will be redirected to our manufacturing facilities in Illinois, Georgia and Texas, which remain in full production mode, along with our Arizona facility. For contact information at all of our facilities click “MORE INFO.”

More Info
2016 - Snap-On - Standing - High

High Snap-On Standing Seam Panel

2016 - Snap-On - Standing - High

High Snap-On Standing Seam Panel

Snap-On panels are ideal for use in roofing, mansard and fascia applications. Snap-On panels are designed to be installed over a waterproofed solid substrate and a minimum 3:12 roof pitch. Snap-On panels are factory roll-formed in continuous lengths. Maximum panel length is 35’ and minimum panel length is 4’. Consult factory for nonstandard lengths.

The simplicity of the pan design combined with leveling provides superior flatness and allows for greater workability on site.

Trim
All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032 – .063 gauge as specified) or PAC-CLAD steel (24 gauge or 22 gauge as specified). A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected. NOTE: The strippable film must be removed immediately after installation.

Installation
Snap-On panels shall be installed over solid decking (5/8” plywood, nailboard insulation or equal) with an underlayment applied horizontally from eave to ridge. Panels shall be fastened using Petersen nonpenetrating clips, fastening on 18” centers (max.). Minimum slope at 3:12 pitch. Consult a local architect or engineer for requirements of local codes and conditions.

Curved Panels
The 1” high Snap-On standing seam panel can be curved to a concave or convex radius, with a minimum radius of 9’. This panel is ideal for barrel vaults and entrance ways. Curved panels must be installed over a waterproofed solid substrate.

  • 43 stocked colors (24 gauge steel)
  • 36 stocked colors (.032 aluminum)
  • Galvalume Plus available

How to install Snap-On Standing Seam Panel

Products
Specs
Company
News